|
| |
TM 9-2320-364-34-4
28-82
28-15. SELF-RECOVERY WINCH MOTOR END SUPPORT REPAIR (CONT).
b.
Disassembly.
NOTE
Perform Step (1) if roll pin from
shifter arm did not fall out during
removal of motor end support.
(1)
Remove and discard roll pin (4) from shifter
arm (5) by lifting motor end support (1)
upward and shaking gently.
(2)
Remove and discard preformed packing (6)
from motor end support (1) or gear end (2).
(3)
Place motor end assembly (1) on side with
shifter arm (5) facing upward.
NOTE
When removing shifter arm, gear
drive will be loose.
(4)
Remove shifter arm (5) from motor end
assembly (1) by pulling upward.
(5)
Remove gear drive shifter (7) from motor
end assembly (1).
(6)
Press bearing (8) from motor end
assembly (1).
(7)
Remove vent (9) from motor end
assembly (1).
(8)
Place motor end (1) on level surface with
bearing side facing upward.
(9)
Remove and discard two preformed
packings (10) from shifter arm (5).
|
