|
| |
TM 9-2320-364-34-4
20-162
20-55. BLOWER DRIVE ASSEMBLY REPAIR (CONT).
NOTE
If clearance is less than 0.005 in.
or more than 0.012 in. (0.127 mm
or 0.31 mm), discard blower
drive assembly.
(9)
Using feeler gage, measure clearance
between thrust washer bearing (6) and thrust
washer bearing (7).
(10)
Bend tangs of lockwasher (8) against sides
of nut (9).
(11)
Install two spring plates (10) on camshaft
hub (11) with three screws (2). Tighten
screws 35 to 39 lb-ft (47 to 53 N.m).
(12)
Install camshaft hub (11) on blower drive
assembly (3) with three screws (13). Tighten
screws 35 to 39 lb-ft (47 to 53 N.m).
END OF TASK
|
