|
| |
TM 9-2320-364-34-4
20-189
(5)
If cylinder liner is glazed, it must be honed.
NOTE
Inside diameter must be
maximum of 4.8415 in.
(12.297 cm) and minimum
of 4.8390 in. (12.291 cm).
Cylinder liner out-of-round
may be maximum of 0.0025
in. (0.0635 mm).
Cylinder liner taper may be
maximum of 0.0025 in.
(0.0635 mm).
If cylinder liner does not
meet specifications, replace
cylinder liner.
(6)
Measure and record inside diameter of
cylinder liner. Measure points A through G
and make two measurements (X, Z and W,
Y) at each point.
NOTE
Top diameter, just below
flange, should be minimum
of 5.3577 in. (13.6086 cm).
Maximum of 5.3595 in.
(13.6131 cm) is acceptable.
Middle diameter should be
minimum of 5.3347 in.
(13.5501 cm) and maximum
of 5.3365 in. (13.5547 cm).
Lower diameter must be
minimum of 5.2142 in.
(13.2441 cm) and maximum
of 5.2160 in. (13.2486 cm).
Replace cylinder liner if any
measurement exceeds
specifications.
(7)
Measure and record outside diameter of
cylinder liner.
|
