|
| |
TM 9-2320-364-34-4
20-198
20-62. CAMSHAFT REPAIR (CONT).
NOTE
Flat side of gear faces away from camshaft.
(10)
Support camshafts (2) and (10) on press.
NOTE
Camshaft gears were removed when camshaft was removed from engine.
(11)
Align keyways in two gears (12) and (13) with keys (11) on camshafts (2) and (10).
(12)
Press gears (12) and (13) on camshafts (2) and (10).
NOTE
Clearance must be minimum of 0.004 in. (0.102 mm) and not exceed limit of 0.018 in.
(0.457 mm). If clearance is not within specifications, replace thrust washers and rear end
bearing.
(13)
Measure clearance between thrust washers (7) and rear end bearing (8).
(14)
Install nut (14) on left camshaft (2).
(15)
Position spacer (15) and screw (16) on right camshaft (10).
END OF TASK
|
