|
| |
TM 9-2320-364-34-4
20-217
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
NOTE
Perform Steps (7) through (14) if
plugs and dowels were removed.
(7)
Coat two plugs (33) and three plugs (34)
with sealing compound.
(8)
Install two plugs (33) and three plugs (34)
in engine block (5).
(9)
Coat two dowels (32) with sealing
compound.
(10)
Install two dowels (32) in front of engine
block (5) until they protrude 3/8 in.
(9.5 mm).
NOTE
Top of plugs must be 1.960 in. (49.784 mm) below surface of block when installed.
(11)
Coat threads of 14 plugs (30) with sealing compound.
(12)
Install 14 plugs (30) in cylinder head screw holes (31). Tighten to 50 to 60 lb-ft
(68 to 81 N.m).
(13)
Coat threads of three dowel pins (29) with sealing compound.
(14)
Install three dowel pins (29) in top of engine block (5) until flush with surface of engine block.
|
