|
| |
TM 9-2320-364-34-4
20-232
20-65. MAIN BEARING AND CRANKSHAFT INSTALLATION (CONT).
(27)
Position two front bearing cap
stabilizers (17) and (18) and two rear
bearing cap stabilizers (19) and (20) on
engine block (21).
(28)
Position seven washers (22) and
lockscrews (23) on bearing cap
stabilizers (17) and (18).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(29)
Apply small amount of International Compound No. 2 to threads of ten screws (15) and surfaces of
stabilizers (17), (18), (19) and (20).
(30)
Position
(31)
Starting with middle two bearing caps (14) of front four bearing caps, tighten eight screws (15) on four
bearing caps to 50 lb-ft (68 N.m).
(32)
Strike four front bearing caps (14) with soft-face hammer and tighten eight screws (15) to
110 lb-ft (149 N.m).
(33)
Strike four front bearing caps (14) with soft-face hammer and tighten eight screws (15) to
230 to 240 lb-ft (312 to 325 N.m).
|
