|
| |
TM 9-2320-364-34-4
20-252
20-73. CAMSHAFT ASSEMBLY INSTALLATION (CONT).
(6)
Turn gears (1) and (3) to reach all rear end
bearing screw holes (4).
(7)
Install six lockwashers (5) and screws (6) in
both camshaft rear end bearings (7) and
engine block (2) and tighten screws (6) 35
to 40 lb-ft (47 to 54 N.m).
(8)
Align holes in three intermediate
bearings (8) on each camshaft with tapered
holes in engine block (2).
(9)
Install six setscrews (9) and tighten
to 20 lb-ft (27 N.m).
(10)
Apply lubricating oil to camshaft front end
bearing journals (10).
NOTE
Gasket is on left hand bearing
only.
(11)
Install gasket (11) and two end bearings
(10) on front of engine block (2).
(12)
Install three lockwashers (12) and
screws (13) in each end bearing (10) and
tighten screws 35 to 40 lb-ft (47 to 54 N.m).
|
