|
| |
TM 9-2320-364-34-4
20-264
20-76. FLYWHEEL HOUSING AND REAR OIL SEAL INSTALLATION (CONT).
Do not lubricate Teflon seal
lip or outside diameter of
crankshaft before seal
installation. Teflon lip seals
must be installed dry to allow
transfer of Teflon to crankshaft
for proper sealing.
(33)
Position guide studs in end of crankshaft (8).
(34)
Install oil seal expander on guide studs
using handle.
(35)
Position seal (40) on oil seal expander.
(36)
Slide seal (40) over oil seal expander and
onto crankshaft (8).
(37)
Remove oil seal expander and guide studs.
(38)
Position guide studs in end of crankshaft (8).
(39)
Position oil seal installer and handle on
guide studs.
(40)
Drive seal (40) with oil seal installer until
seal seats squarely in flywheel housing (4).
|
