|
| |
TM 9-2320-364-34-4
20-276
20-82. VIBRATION DAMPER AND FRONT BALANCE COVER INSTALLATION (CONT).
(5)
Coat gasket (32) with grease.
(6)
Position gasket (32) on front cover (10).
(7)
Align holes on front balance cover (10) with
holes in end plate (33) and position front
balance cover (10) on end plate (33).
(8)
Install three washers (31), screws (30),
lockwashers (29) and nuts (28). Tighten
nuts 30 to 35 lb-ft (41 to 47 N.m).
(9)
Install screw (22), washer (23),
lockwasher (21) and nut (20) in front
cover (10). Tighten nut 35 to 39 lb-ft
(47 to 53 N.m).
(10)
Install screw (24), lockwasher (25),
washer (26) and locknut (27). Tighten
locknut 35 to 39 lb-ft (47 to 53 N.m).
(11)
Install washer (19), lockwasher (18) and
screw (17). Tighten screw 35 to 39 lb-ft
(47 to 53 N.m).
(12)
Install clip (16), two washers (15),
lockwashers (14) and screws (13) in front
cover (10). Tighten screws 30 to 35 lb-ft
(41 to 47 N.m).
|
