|
| |
TM 9-2320-364-34-4
20-355
(5)
Install switch bracket assembly (141) on
engine block (12) with two washers (140),
lockwasher (139) and screws (138).
(6)
Remove two screws (130) from oil pressure
switch (133).
(7)
Install wire 1517 (131) and wire 1871 (132)
on oil pressure switch (133) with two screws
(130).
(8)
Connect wire 1032 (128) to oil pressure
switch (129).
(9)
Remove nut (124) and washer (127) from
oil pressure sending unit (123).
(10)
Install washer (127), wire 1113 (126),
lockwasher (125) and nut (124) on oil
pressure sending unit (123).
NOTE
If equipped with 200 AMP
alternator perform Steps (11)
through (13).
(11)
Remove two screws (134) from oil
pressure switch (137).
(12)
Install wire 1020B (136) and wire 1020A
(135) on oil pressure switch (137) with
two screws (134).
Adhesives, solvents, and sealing
compounds can burn easily can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a
well-ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water.
(13)
Apply electrical sealant to sending unit
(123) terminal and two screws (134).
(14)
Install wire 1435 (122) on oil pressure sending
unit (123).
(15)
Connect hose 2682 (120) to adapter (121).
120
130
121
126
125
124
127
123
122
137
136
134
132
128
129
135
133
131
|
