|
| |
TM 9-2320-364-34-4
20-359
(43)
Position alternator (72) and screw (74) in
bottom of alternator bracket (75).
(44)
Rotate alternator (72) towards center of
engine (12) and install two belts (73). Slide
alternator (72) into original position.
(45)
Position locknuts (71) on screw (74).
NOTE
Install same number of washers
as removed.
(46)
Position washers (70), alternator support
arm (60) on engine (12) with lockwasher
(69) and screw (68).
(47)
Position locknut (59), washer (67), eye rod
end (64), washer (66) and locknut (65) on
alternator support arm (60).
(48)
Position washer (63), lockwasher (62) and
screw (61) in eye rod end (64).
(49)
Tighten screw (68) to 137 to 147 lb-ft
(186 to 199 N.m).
(50)
Tighten screw (61) to 50 to 55 lb-ft
(67 to 75 N.m).
|
