|
| |
TM 9-2320-364-34-4
21-7
(26)
Loosen two screws (42) three turns.
NOTE
Matchmark rear bearing
retainers.
(27)
Remove six screws (43) and two flat
bearing retainers (44) from rear end plate
(45). Discard screws.
(28)
Remove two screws (42) from rear end
plate (45).
NOTE
Six puller screws must be 1/4-20
by 1-1/4 in.
(29)
Install puller on rear end plate (45) with
two screws (25).
(30)
Install puller on rear end plate (45) with
three screws (25).
Keep hands and fingers clear
of rotors. If rotors turn, fingers
may get caught between rotors
and result in injury to personnel.
(31)
Turn both puller screws (26) evenly
clockwise and remove rear end plate (45)
from blower (7).
(32)
Remove pullers and five screws (25) from
rear end plate (45).
|
