|
| |
TM 9-2320-364-34-4
21-8
21-2. BLOWER ASSEMBLY REPAIR (CONT).
(33)
Remove two screws (46) from front end
plate (39).
NOTE
Matchmark front end plate
and indicate top.
Matchmark front end of
blower housing and indicate
top.
Use 1/4-20 by 1 1/4 in.
screws on pullers.
(34)
Install two pullers on front end plate (39)
with six screws (47).
(35)
Turn both puller screws (26) evenly
clockwise and remove front end plate (39).
(36)
Remove two pullers and six screws (47)
from front end plate (39).
Handle rotors with care to avoid
scratching surfaces. Scratching
surface may cause damage to parts.
NOTE
Rotors are marked left and
right as viewed from rear of
blower.
Both rotors are removed at
same time.
Matchmark front right and
front left rotors to each other
before removal.
(37)
Remove right rotor (48) and left rotor (49)
from blower (7).
|
