|
| |
TM 9-2320-364-34-4
21-9
(38)
Install puller and adapter on bearing
race (50).
(39)
Remove bearing race (50) from left front
rotor (49).
(40)
Remove bearing race (50) from puller.
(41)
Remove and discard oil seal (51) from left
front rotor (49).
NOTE
Repeat Steps (42) through (44)
for left and right bore.
(42)
Position rear end plate (45) on wooden
blocks with seal (52) facing upward.
(43)
Place long end of remover and installer tool
in bore (53) through seal (52) into ball
bearing (54).
(44)
Remove ball bearing (54) and seal (52)
from rear end plate (45). Discard seal.
(45)
Place long end of remover and installer tool
in right bore (55) of front end plate (39)
through seal (56) and in roller bearing (57).
(46)
Remove roller bearing (57) and seal (56)
from front end plate (39). Discard seal.
NOTE
Inner bearing race, removed in
Step (39), may be positioned in
left roller bearing for support.
(47)
Install long end of remover and installer
tool in left bore (58) of front end plate (39)
through seal (59) and in roller bearing (60).
(48)
Remove roller bearing (60) and seal (59)
from front end plate (39). Discard seal.
|
