|
| |
TM 9-2320-364-34-4
21-30
21-3. TURBOCHARGER ASSEMBLY REPAIR (CONT).
c.
Assembly.
(1)
Position center housing (6) in soft jawed vise.
Use care when installing retaining
rings. Retaining rings are under
tension and can act as projectiles
when released causing injury to
personnel.
(2)
Install retaining ring (29) in center
housing (6).
(3)
Install thrust washer (28), bearing (27) and
retaining ring (26) in center housing (6).
(4)
Install retaining ring (25), washer (24) and
bearing (23) in center housing (6).
(5)
Install shaft collar (22) in thrust washer
bearing (21).
(6)
Install center housing (6) in soft-jaw vise
and install thrust washer bearing (21) in
center housing (6) with three screws (20).
Tighten screws to 25 lb-in (3 N.m).
(7)
Install seal ring (18) in center housing (6).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(8)
Coat threads of connector (19) with sealing
compound.
(9)
Install connector (19) in center housing (6). Tighten to 240 lb-in (27 N.m).
(10)
Coat sleeve spacer (16) with grease.
|
