|
| |
TM 9-2320-364-34-4
21-31
(11)
Install two seal rings (17) on sleeve
spacer (16).
(12)
Install sleeve spacer (16) in compressor
backplate (3).
(13)
Align matchmark and install backplate (3)
in center housing (6).
(14)
Install four screws (15) through
backplate (3) into center housing (6).
Tighten screws 80 to 100 lb-in (9 to 11 N.m).
(15)
Remove center housing (6) from soft-jaw
vise.
(16)
Install retaining ring (14) on turbine wheel
assembly shaft (9).
(17)
Install turbine wheel shroud (13) on turbine
wheel shaft (9).
Use care when installing retaining
rings. Retaining rings are under
tension and can act as projectiles
when released causing injury to
personnel.
(18)
Fill ring groove in turbine wheel shroud
(13) with grease and install retaining
ring (12) in groove.
|
