|
| |
TM 9-2320-364-34-4
23-53
NOTE
Components must be installed in original location. Tag and mark all valve parts.
(14)
Remove two screws (21) from torque
converter housing (1) to permit installation
of spring compressor.
(15)
Install spring compressor on torque
converter housing (1).
(16)
Tighten spring compressor on main pressure
regulator valve retaining washer (22).
Use care when removing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released causing
injury to personnel.
Compress retaining washer just
so retaining ring is cleared or
damage to valve may occur.
(17)
Using spring compressor, compress
retaining washer (22) and remove retaining
ring (23).
Use extreme care when handling
all valve parts. Do not nick or
bump valves or damage may
result.
(18)
Slowly release pressure of spring compressor
and remove spring compressor from torque
converter housing (1).
(19)
Remove retaining washer (22), valve
stop (24), valve spring (25) and main
pressure regulator valve (26) from front
support assembly (27). Discard spring.
|
