|
| |
TM 9-2320-364-34-4
23-54
23-12. TORQUE CONVERTER HOUSING REPAIR (CONT).
Use care when removing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released
causing injury to personnel.
(20)
With the aid of an assistant, compress
retaining washer (28), and remove retaining
ring (29) from front support assembly (27).
(21)
Remove retaining washer (28), valve
stop (30), valve spring (31) and lockup shift
valve (32) from front support assembly (27).
Discard spring.
(22)
Compress valve support (33) and remove
retaining ring (34) from front support
assembly (27).
(23)
Remove valve support (33), valve seat (35),
converter bypass valve (36) and valve
spring (37) from front support
assembly (27). Discard spring.
NOTE
Perform Steps (24) through (26)
only if bearing is damaged.
(24)
Install bearing remover on bearing (38).
(25)
Install adapter on bearing remover.
(26)
Using bearing remover, adapter and slide
hammer, remove bearing (38) from ground
sleeve bore (39).
(27)
Remove bearing remover from bearing (38).
Discard bearing.
(28)
Remove 14 screws (40) from front support
assembly (27).
(29)
Remove three screws (41) from front
support assembly (27).
(30)
Remove front support assembly (27) from
torque converter housing (1).
(31)
Remove and discard gasket (42) from
torque converter housing (1).
|
