|
| |
TM 9-2320-364-34-4
23-83
d.
Assembly.
NOTE
Perform Steps (1) and (2) only if
balls were removed.
(1)
Lubricate balls (13) with hydraulic oil.
NOTE
Staking must retain eight balls
with 30 psi of air pressure
applied from front of fifth clutch
housing through bleed hole.
(2)
Position balls (13) in fifth clutch housing (2)
and stake fifth clutch housing.
(3)
Apply hydraulic oil to seal (11) and
gasket (12).
(4)
Install seal (11) and gasket (12) in grooves
on piston (10), with lip of seal rings facing
bottom of piston cavity.
(5)
Install piston (10) into fifth clutch
housing (2).
(6)
Install 20 piston return springs (9) in
piston (10).
(7)
Install spring retainer (8) with outer lip down on piston return springs (9).
Use care when installing retaining rings. Retaining rings are under tension and can act as
projectiles when released causing injury to personnel.
(8)
Position spring compressor on spring retainer (8) and position fifth clutch housing (2) in press.
(9)
Compress spring retainer (8) until retaining ring groove on clutch hub is visible.
(10)
Install retaining ring (7) in fifth clutch housing (2).
|
