|
| |
TM 9-2320-364-34-4
23-97
(3)
Apply hydraulic oil to preformed
packings (1) and (2).
NOTE
Ensure lips of preformed
packings are facing away from
springs.
(4)
Install inner preformed packing (1) and
outer preformed packing (2) in fourth clutch
piston (3).
Install fourth clutch piston
slowly in center support or
damage to seal rings may occur.
NOTE
Center support should be hub
side facing up prior to
installation of fourth clutch
piston.
(5)
Apply hydraulic oil to center support (4).
(6)
Install fourth clutch piston (3) in center
support (4).
(7)
Install 20 springs (5) in fourth clutch
piston (3).
(8)
Install spring retainer plate (6) on fourth
clutch piston (3).
NOTE
Spring retainer plate must be
compressed evenly to sit
properly in center support.
(9)
Using lock ring installer, install four push-on
nuts (7) on fourth clutch piston (3).
|
