|
| |
TM 9-2320-364-34-4
23-126
23-18. REAR TRANSMISSION COVER ASSEMBLY REPAIR (CONT).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(26)
Coat outer surface of dust shield (9) with
adhesive (RTV 108).
NOTE
Install dust shield in rear
cover until rear edge of dust
shield is flush with surface of
rear cover.
Dust shield is installed in
rear cover flat side first.
(27)
Install dust shield (9) in rear cover (8).
(28)
Coat splines of output shaft (3) with
adhesive (RTV 732).
(29)
Install yoke (2) on output shaft (3).
(30)
Position retainer nut (1) on output shaft (3).
(31)
Apply sealing compound to threads of
screw (4).
(32)
Apply hydraulic oil to preformed
packing (7).
(33)
Install preformed packing (7), magnetic
speed sensor (6), speed sensor retainer (5)
and screw (4) in rear cover (8).
NOTE
Perform Step (34) only if plug
was removed.
(34)
Install plug (12) in rear cover (8).
|
