|
| |
TM 9-2320-364-34-4
23-132
23-19. FIRST CLUTCH AND ADAPTER HOUSING REPAIR (CONT).
d.
Assembly.
NOTE
Perform Steps (1) and (2) only if
dowel pins and lube orifice plug
were removed.
(1)
Install two dowel pins (8) and (9) in adapter
housing (2).
(2)
Install lube orifice plug (10) in adapter
housing (2).
(3)
Lubricate outer seal ring (3) and inner
seal (4) with hydraulic oil.
(4)
Install outer seal ring (3) and inner seal
ring (4) in second clutch piston (1) with lips
of seal rings facing away from spring side of
piston.
Make sure second clutch piston
is fully seated in adapter housing.
If second clutch piston is not
fully seated upon installation of
spring retainer ring, proper clutch
clearance cannot be established.
(5)
Install second clutch piston (1) in adapter housing (2).
(6)
Install 28 springs (7) in second clutch piston (1).
NOTE
Offset tangs of retaining ring face upward.
(7)
Install spring retainer ring (6) in second clutch piston (1).
NOTE
Push-on nuts are installed until retainer tangs on spring retainer ring bottom out in
counterbore of adapter housing.
(8)
Using lock ring installer, install four push-on nuts (5) on second clutch piston (1).
|
