|
| |
TM 9-2320-364-34-4
23-133
e.
Installation.
(1)
Install gasket (6) on transmission
housing (5).
NOTE
Position adapter housing so
rounded end of adapter housing
faces valve body side of
transmission housing.
(2)
Install adapter housing (4) on transmission
housing (5).
(3)
Soak eight internal-splined plates (3) in
hydraulic oil for minimum of two minutes.
NOTE
Assemble clutch plates so
that cone of each plate faces
same direction as cone of
adjacent plate.
Install external-tanged
clutch plates so thickest
plates are installed last.
Aligning splines in internal
splined clutch plates during
installation will allow for
easy installation of first
planetary ring gear.
(4)
Alternately install five external-tanged
clutch plates (2) and four internal-splined
clutch plates (3) in transmission housing (5).
(5)
Install first planetary ring gear (1) in adapter housing (4), small diameter first.
(6)
Install remaining external-tanged clutch plates (2) and four internal-splined clutch plates (3) in
transmission housing (5) beginning with internal-splined clutch plate (3) and alternating with
external-tanged clutch plate (2).
f.
Follow-On Maintenance:
Install rear transmission cover assembly, (Para 23-18).
END OF TASK
|
