| |
TM 9-2320-364-34-4
24-13
b.
Installation.
NOTE
Perform Step (1) only if tang was
removed.
(1)
Install tang (2) in sending unit (1).
(2)
Pack inside of sending unit (1) with
grease.
Use caution when installing parts
in bearing cap. Parts can easily
fall in transfer case housing.
Failure to comply may result in
damage to equipment.
(3)
Install speedometer shaft (7), spring (8),
washer (6) and thrust bearing (5) as an
assembly in bearing cap (4).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(4)
Coat outside threads of sleeve (3) with sealing compound.
(5)
Install sleeve (3) in bearing cap (4).
(6)
Align tang (2) in sending unit (1) with slot in speedometer shaft (7).
Do not overtighten sending unit so it moves sleeve, or sending unit could be damaged.
(7)
Install sending unit (1) on sleeve (3).
c.
Follow-On Maintenance:
Install neutral start switch, (Para 24-5).
END OF TASK
|