|
| |
TM 9-2320-364-34-4
24-16
24-7. TRANSFER CASE YOKE REPLACEMENT (CONT).
b.
Installation.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
NOTE
Ensure splines of yoke and shaft are clean.
Install yokes as noted prior to removal.
(1)
Apply adhesive to splined surface inside
yoke (4).
NOTE
It may be necessary to use a soft
hammer to install yoke.
(2)
Install yoke (4) on shaft (3).
(3)
Apply sealing compound to threads in center
of shaft (3).
(4)
Coat end of shaft (3) with adhesive.
(5)
Install washer (2) on screw (1).
(6)
Apply sealing compound to threads of
screw (1).
(7)
Position washer (2) on shaft (3) with
screw (1).
(8)
Position flange holder on yoke (4).
(9)
Tighten screw (1) on yoke (4) to 375 lb-ft
(509 N.m).
(10)
Remove flange holder from yoke (4).
c.
Follow-On Maintenance:
Install speedometer sensor, (Para 24-6).
END OF TASK
2
1
FLANGE
HOLDER
4
3
ADHESIVE
|
