|
| |
TM 9-2320-364-34-4
24-18
24-8. TRANSFER CASE ASSEMBLY REPAIR (CONT).
(3)
Remove cap nut (8) and preformed
packing (9) from top of air chamber (10).
Discard preformed packing.
(4)
Remove and discard locknut (11) and
washer (12) from inside top of air
chamber (10).
(5)
Remove two screws (13) and
lockwashers (14) from base of air
chamber (10). Discard lockwashers.
(6)
Remove air chamber (10) from rear
housing (4).
(7)
Remove and discard washer (15) from end
of shift rod (16).
NOTE
Perform Step (8) only if stud is
damaged.
(8)
Remove stud (17) from shift rod (16).
Rear shaft assembly weighs 100
lbs (45 kg). Attach suitable
lifting device to prevent possible
injury to personnel.
(9)
Attach lifting eye and lifting device on
center of rear shaft assembly (18).
(10)
Remove six screws (19) and
lockwashers (20) from rear shaft
assembly (18). Discard lockwashers.
(11)
Using lifting device and lifting eye, remove
rear shaft assembly (18) from rear
housing (4).
(12)
Remove lifting device and lifting eye from
rear shaft assembly (18).
|
