|
| |
TM 9-2320-364-34-4
24-40
24-8. TRANSFER CASE ASSEMBLY REPAIR (CONT).
(73)
Attach lifting eye and lifting device to end of
center shaft assembly (45).
(74)
Coat lower bearing (97) on center shaft
assembly (45) with grease.
Center shaft assembly weighs
145 lbs (66 kg). Attach suitable
lifting device before installation
to prevent possible injury to
personnel.
(75)
Using lifting device, install center shaft
assembly (45) in front housing (33).
(76)
Seat center shaft assembly (45) in front
housing (33).
(77)
Remove lifting device and lifting eye from
center shaft assembly (45).
(78)
Install plate (44) and two screws (43) on
center shaft assembly (45). Tighten to
40 lb- ft (54 N.m).
NOTE
Long shoulder on clutch collar
should be positioned up toward
stud on shift rod.
(79)
Coat clutch collar (42) and differential
shaft assembly (57) with grease.
(80)
Install lower shift fork assembly (41) and
clutch collar (42) in front housing (33) and
over differential shaft assembly (57).
42
57
41
33
LIFTING
DEVICE
LIFTING EYE
45
97
43
44
33
|
