|
| |
TM 9-2320-364-34-4
25-42
25-11. AXLE NO. 2 LOCKING CYLINDER REPLACEMENT (CONT).
(20)
Connect air supply hose to locking cylinder
(7).
(21)
Using air supply hose, apply air pressure
100 to 120 psi (690-827 kPa) to locking
cylinder (7).
NOTE
When locking cylinder engages
both hub gears will turn in same
direction, while rotating one
wheel.
(22)
Turn flange assembly (16) back and forth
until locking cylinder (7) engages.
(23)
Turn screw (1) slowly until screw contacts
fork (17) in differential (8).
(24)
Using caliper, measure distance between
face of washer (2) and top of locking
cylinder (7) and record as measurement “B”
(25)
Determine shim (3) thickness. Shim
thickness is: measurement “B” - 0.004
in. (0.102 mm) to 0.020 in. (0.508 mm).
(26)
Remove screw (1) and washer (2).
NOTE
Shim thickness is determined in
Step (25).
(27)
Install shim (3), washer (2) and screw (1).
Tighten screw 25 to 32 lb-ft (34 to 43 N.m).
(28)
Remove air supply hose from locking cylinder
(7).
c.
Follow-On Maintenance:
Install tie rod, (Para 25-9).
END OF TASK
|
