|
| |
TM 9-2320-364-34-4
25-51
Adhesives, solvents and sealing
compounds can burn easily, can
give off harmful vapors and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(28)
Coat mating surface of spindle assembly (5)
with adhesive.
(29)
Install shim (7), thickness determined in
Step (24), on pivot and spindle assembly (5).
(30)
Install steering arm (3) on pivot and spindle
assembly (5).
(31)
Install four screws (4). Tighten screws to
100 lb-ft (136 N.m).
(32)
Install grease fitting (1) on upper cover (3).
(33)
Rotate pivot and spindle assembly (5)
around three times to check for excessive
play or force. If incorrect, repeat Steps (16)
through (31).
(34)
Tighten four screws (4) first to 250 lb-ft
(339 N.m), then to 500 lb-ft (678 N.m) and
then to 720 to 800 lb-ft (976 to 1,085 N.m).
(35)
With torque wrench on screw (4), verify that
pivot and spindle assembly (5) requires
between 57 to 72 lb-ft (77 to 98 N.m) to start
rotation of the pivot and spindle assembly
about its pivot from the centered position. If
incorrect, repeat Steps (14) through (32).
e.
Follow-On Maintenance:
Install locking cylinder, (Para 25-10 or 25-11).
END OF TASK
|
