|
| |
TM 9-2320-364-34-4
25-85
(26)
Remove screw (31) and nut lock plate (32)
from bearing cap (33).
NOTE
Bearing caps are part of a
matched assembly with housing
assembly.
(27)
Remove four screws (34), two bearing
caps (33) and adjusting nut (35) from
housing assembly (15).
NOTE
Perform Step (30) only if
locating pins are damaged.
(28)
Remove four locating pins (36) from
housing assembly (15).
Differential and bevel gear weigh
70 lbs (32 kg). Attach suitable
lifting device prior to removal to
prevent possible injury to
personnel.
NOTE
Differential and bevel gear
assembly is part of a matched
assembly with pinion shaft.
(29)
Attach lifting device to differential gear (2).
(30)
Using lifting device, remove differential
gear (2) from housing assembly (15).
(31)
Remove lifting device from differential
gear (2).
NOTE
Tag and mark bearings and races
before removal. Bearing races
are part of matched assemblies
with taper bearings.
(32)
Remove bearing races (37) and (38) and
adjusting shim (39) from differential gear (2).
Record and discard adjusting shim.
(33)
Using puller, remove taper bearings (40)
and (41) from differential gear (2).
|
