| |
TM 9-2320-364-34-4
25-86
25-16. AXLE NO. 2 DIFFERENTIAL ASSEMBLY REPAIR (CONT).
NOTE
Nut is staked in two places.
(34)
Unstake nut (42) on pinion shaft (3).
(35)
Position jet extractor between gear teeth of pinion shaft (3) and housing assembly (15). Remove
adjusting nut (42). Discard adjusting nut.
NOTE
Pinion shaft is part of a matched assembly with differential and bevel gear.
(36)
With the aid of an assistant and using a soft faced hammer, remove pinion shaft (3) from housing
assembly (15).
(37)
Remove driven gear (43) from housing assembly (15).
NOTE
Taper bearings are part of a matched assembly with bearing races.
(38)
Remove taper bearing (44), adjusting shim (45) from housing assembly (15). Record adjusting shim
thickness and discard.
(39)
Using press, remove taper bearing (46) and adjusting shim (47) from pinion shaft (3). Record shim
thickness and discard.
(40)
Using puller, remove bearing races (48) and (49) from housing assembly (15).
|