|
| |
TM 9-2320-364-34-4
25-89
(18)
Position jet extractor between gear teeth of
pinion shaft (3) and install adjusting
nut (42). Tighten nut to 543 to 572 lb-ft
(736 to 776 N.m).
(19)
Using a torque wrench, check preload of
pinion shaft (3). Preload must be 48 lb-in
(5 N.m).
NOTE
If preload is correct, go on to
Step (20).
If preload is incorrect, repeat
Steps (1) through (19) until
proper preload is obtained.
(20)
Stake adjusting nut (42) in two places.
(21)
Install taper bearing (41) on differential
gear (2).
(22)
Install taper bearing (40) on differential
gear (2).
(23)
Assemble new adjusting shim (39) thickness
by applying opposite change of thickness
applied to adjusting shim kit (47) in
Step (6).
(24)
Install adjusting shim (39) and bearing
races (38) and (37) on differential gear (2).
|
