|
| |
TM 9-2320-364-34-4
25-88
25-16. AXLE NO. 2 DIFFERENTIAL ASSEMBLY REPAIR (CONT).
(4)
The new adjusting shim (47) thickness will be: Step (1) distance – Step (2) distance = amount of shim
thickness to be added to old adjusting shim thickness to create new adjusting shim. Proceed to Step (6).
(5)
The new adjusting shim (47) thickness will be: Step (2) distance – Step (1) distance = amount of shim
thickness to be removed from old adjusting shim to create new adjusting shim. Proceed to Step (6).
(6)
Assemble adjusting shim (47) to thickness determined in Steps (1) through (5).
(7)
Assemble adjusting shim (45) thickness by applying same change of thickness applied to adjusting
shim (47).
(8)
Apply grease to bearing race (49).
(9)
Install bearing race (49) in housing assembly (15).
(10)
Apply grease to bearing race (48).
(11)
Install bearing race (48) in housing assembly (15).
(12)
Install taper bearing (46) on pinion shaft (3).
(13)
Install adjusting shim (47) on pinion shaft (3).
(14)
Install driven gear (43) in housing assembly (15).
(15)
Install pinion shaft (3) in housing assembly (15).
(16)
Install adjusting shim (45) on pinion shaft (3).
(17)
With the aid of an assistant, hold pinion shaft (3) in place and install taper bearing (44) on pinion shaft.
15
45
44
43
47
46
3
49
48
|
