|
| |
TM 9-2320-364-34-4
25-135
b.
Disassembly.
(1)
Using puller, remove spindle ring (1) from
spindle (2).
(2)
Heat seal race (3) with propane torch.
Seal race is extremely hot. Do
not touch seal race without
protective gloves or severe burns
to hands could result.
(3)
Using puller and press, remove seal race (3)
from spindle (2).
c.
Cleaning/Inspection.
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees
C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
(1)
Clean all metal parts with drycleaning solvent.
(2)
Inspect metal parts for breaks, cracks, burrs and sharp edges.
(3)
Inspect seal race for wear, scoring and cracks.
|
