| |
TM 9-2320-364-34-4
25-139
b.
Installation.
NOTE
Steps (1) and (2) are for left side axle shaft only.
Step (3) is for the right side axle shaft only.
The end of axle shaft with long splines goes in axle housing.
(1)
Install axle shaft (1) in axle housing (5) by aligning axle splines of axle shaft with differential carrier
splines and pushing axle shaft inward until axle shaft bottoms out.
(2)
Remove screw (3) and wire from fingers of fork (2).
(3)
Install axle shaft (4) in axle housing (5) by aligning axle splines of axle shaft with differential carrier
splines and pushing axle shaft inward until axle shaft bottoms out.
c.
Follow-On Maintenance:
Install Axle No. 3 or 4 spindle, (Para 25-24).
END OF TASK
|