|
| |
TM 9-2320-364-34-4
25-179
(20)
Install ten washers (16) and locknuts (12) on
studs (13). Tighten nuts to 140 to 152 lb-ft
(190 to 206 N.m).
NOTE
Perform Steps (21) and (22)
only if nut and stud was
removed.
Nut is installed all the way to
end of threads and next to
shoulder on stud.
(21)
Apply sealing compound to stud (11) and
install in axle housing (15).
(22)
Install nut (10) on stud (11).
Adhesives, solvents and sealing
compounds can burn easily, can
give off harmful vapors and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(23)
Coat bottom face of washers (8) with
adhesive.
(24)
Install washers (8) and locknuts (7) on four
studs (9). Tighten nuts to 117 to 137 lb-ft
(159 to 186 N.m).
|
