|
| |
TM 9-2320-364-34-4
27-11
Materials/Parts
Grease (Item 21, Appendix B)
Oil, Hydraulic (Item 34, Appendix B)
Sealing Compound (Item 56, Appendix B)
Solvent, Drycleaning (Item 68, Appendix B)
Tape, Masking (Item 74, Appendix B)
Front/Rear Steering Gear Repair Kit
(Item 52, Appendix E)
Lockwasher (20) (Item 251, Appendix E)
Lockwasher (8) (Item 287, Appendix E)
This task covers:
a. Disassembly
b. Cleaning/Inspection
c. Assembly
INITIAL SETUP
Equipment Condition
Front or rear steering gear on clean work
surface
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Compressor Unit, Air (Item 35, Appendix F)
Drill Machine, Upright (Item 47, Appendix F)
Drill Set, Twist (Item 48, Appendix F)
Gloves, Chemical Oil Protective
(Item 81, Appendix F)
Goggles, Industrial (Item 83, Appendix F)
Gun, Airblow (Item 86, Appendix F)
Hammer, Hand, Soft Plastic
(Item 88, Appendix F)
Pan, Drain (Item 145, Appendix F)
Press, 60 Ton (Item 164, Appendix F)
Puller Kit, Universal (Item 174, Appendix F)
Vise, Chain, Pipe (Item 249, Appendix F)
Wrench, Torque (0 to 175 lb-ft [0-237 N.m])
(Item 277, Appendix F)
27-3. FRONT AND REAR STEERING GEAR REPAIR.
a.
Disassembly.
NOTE
Front and rear steering gear are
repaired the same way.
(1)
Position steering gear housing (1) in chain
vise.
(2)
Matchmark gear housing (1), cover (2),
bearing cap (3) and cylinder head (4).
(3)
Remove eight screws (5) and
lockwashers (6) from cover (2). Discard
lockwashers.
(4)
Using a soft faced hammer, tap back end of
shaft (7) to remove cover (2) and shaft (7)
from gear housing (1).
|
