|
| |
TM 9-2320-364-34-4
27-16
27-3. FRONT AND REAR STEERING GEAR REPAIR (CONT).
c.
Assembly.
NOTE
Perform Steps (1) through (10) if seals and actuating shaft were removed.
Backup washer must be installed with undercut facing outside of bearing cap.
(1)
Install backup washer (31) in bearing
cap (3).
NOTE
Lip of high pressure seal
must face away from
backup washer.
High pressure seal must be
fully seated against backup
washer.
(2)
Install high pressure seal (30) in bearing
cap (3).
NOTE
Lip of dirt seal must face
away from backup washer.
Dirt seal must be fully
seated against backup
washer.
(3)
Install dirt seal (33) in bearing cap (3).
NOTE
Lip of salt seal must face
outside end of bearing cap.
Outer edge of dirt seal must
be flush with outside edge
of bearing cap.
(4)
Install salt seal (32) in bearing cap (3).
(5)
Apply grease to lip of dirt seal (32) and salt
seal (33).
(6)
Apply hydraulic oil to lip of high pressure
seal (30).
|
