|
| |
TM 9-2320-364-34-4
27-23
(12)
Remove four screws (16) and
lockwashers (17) from bearing cap (18).
Discard lockwashers.
(13)
Remove bearing cap (18) and piston
assembly (19) from steering gear
assembly (1).
NOTE
Perform Steps (14) through (26)
only if seals in the bearing cap
are leaking or damaged.
(14)
Install screw (20) in plug (21) on piston
assembly (19).
(15)
Remove plug (21) from piston
assembly (19).
(16)
Remove screw (20) from plug (21).
Discard plug.
(17)
Remove preformed packing (22) from
plug (21). Discard preformed packing.
(18)
Remove both halves of guides (23) from
ball cavity in piston assembly (19).
(19)
Remove 24 steel balls (24) from ball cavity
while turning piston assembly (19) so that
ball cavity is facing downward and rotate
actuating shaft (25) and bearing cap (18) in
and out of the piston assembly (19).
|
