|
| |
TM 9-2320-364-34-4
27-25
(25)
Using a soft faced hammer, tap splined end of
actuating shaft (25) and remove actuating
shaft (25) and bearing (31) from bearing
cap (18).
NOTE
Seals and backup washer are
removed by pressing all three
seals towards inside of cylinder
head.
(26)
Position bearing cap (18) with machined
surface down and remove seal (32), backup
washer (33) and seals (34) from bearing cap
(18). Discard seals.
(27)
Remove and discard cap (35), set screw
(36) and ball (37) from bearing cap (18)
and cylinder head (14).
NOTE
Perform Step (28) if grease fitting
is damaged.
(28)
Remove grease fitting (38) from bearing
cap (18).
36
37
14
35
35
36
37
18
38
|
