| |
TM 9-2320-364-34-4
28-42
28-8. HYDRAULIC HOIST MOTOR REPAIR (CONT).
(5)
Install bearing (16) and shaft (15) in
motor (1).
(6)
Install shaft (13) in shaft (15).
NOTE
Only timing marks on one end of
shaft will line up.
(7)
Align timing mark on shaft (13) with timing
mark on shaft (15).
(8)
Apply hydraulic oil to preformed
packing (14).
(9)
Install preformed packing (14) and
plate (11) on motor (1).
NOTE
Perform Steps (10) and (11) if
geroler was disassembled.
(10)
Apply hydraulic oil to preformed
packing (12).
(11)
Install seven rollers (10), star (9) and
preformed packing (12) in geroler (8).
(12)
Install geroler (8) as an assembly and align
any star point with timing mark on
shaft (15).
(13)
Apply hydraulic oil to preformed
packing (7).
(14)
Install preformed packing (7) and end
cap (6) on motor (1) with seven seal
washers (5) and screws (4). Tighten screws
175 to 200 lb-in. (20 to 23 N.m).
(15)
Apply hydraulic oil to preformed
packing (3).
(16)
Install preformed packing (3) and elbow (2).
END OF TASK
|