Click here to make tpub.com your Home Page

Page Title: AUXILIARY LIGHT BAR MARKER LIGHTS AND TAILLIGHTS DO NOT OPERATE. (Cont)
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2330-385-14
Remove all jewelry such as rings, dog tags,
S
bracelets, etc. If jewelry or tools contact
positive electrical circuits, a direct short
may result. Damage to equipment, injury, or
death to personnel may occur.
Resistors mounted on exterior of junction box
S
assembly reach very high temperatures when
power is applied to circuit. Avoid touching
or contacting resistors when working in or
around junction boxes. Failure to comply
could result in injury to personnel.
VOLTAGE TEST
(1) Disconnect auxiliary light bar 24 vdc
(12 terminal) cable from rear
crossbrace connector.
(2) Set multimeter select switch to volts
DC.
(3) Connect positive (+) multimeter lead
to terminal E on trailer end connector.
(4) Connect negative (--) multimeter lead
to terminal D on trailer end connector.
(5) While assistant turns ON ENGINE
switch and turns on LIGHT switch,
observe multimeter,
(TM 9-2320-364-10).
(a) If 22 to 28 vdc are not present,
perform Steps (6) and (7) below
and replace auxiliary light bar
24 vdc cable, (Para 4-30).
(b) If 22 to 28 vdc are present, auxiliary
A
J
light bar 24 vdc cable is OK.
(6) Turn off LIGHT switch.
B
K
H
(7) Turn OFF ENGINE switch.
(8) Connect auxiliary light bar 24 vdc cable
L
N
to rear crossbrace connector.
C
M
F
PIN E
PIN D
D
E
AUXILIARY
LIGHT BAR
24 VDC CABLE

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business