|
|
TM 9-2330-385-14
4-13. 24 VOLT ELECTRICAL SYSTEM TROUBLESHOOTING PROCEDURES (CONT).
15. TAILLIGHT(S) DO NOT OPERATE (S/N YB6122 075 AND UP).
INITIAL SETUP
Tools and Special Tools
References
Tool Kit, General Mechanic's: Automotive
TM 9-2320-364-10
Equipment Condition
(Item 50, Appendix J)
Engine OFF, (TM 9-2320-364-10)
Multimeter (Item 28, Appendix J)
24 vdc cable assembly connected to truck,
Personnel Required
Two
Parking brake applied, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
NOTE
The following troubleshooting procedures cover the left taillight, but they apply to both taillights.
D
All electrical wires and components listed in this troubleshooting procedure are illustrated and located in FO-1.1.
D
START
1.
KNOWN INFO
TEST OPTIONS
WARNING
Read WARNING
Truck electrical system OK.
Continuity test.
on Page 118.21
All other lights on trailer
operate.
REASON FOR QUESTION
If LED composite light ground
Is continuity measured be-
POSSIBLE PROBLEMS
is faulty, LED composite light
tween wire 1435 at LED com-
will not operate.
Wire 1435 faulty.
posite light and a known good
LED composite light faulty.
ground?
Wire 1008B/21 faulty.
Wire 1008B faulty.
Wire 1008C faulty.
Diode assembly faulty.
Repair wire 1435 (see
schematic Fig FO-1.1)
or replace rear side
NO
marker light wire
harness (Para 4-30.1).
Verify repair, go to
Step 6 of this Fault.
YES
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |