|
|
![]() TM 9-2330-385-14
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
CONTINUITY TEST
(1) Remove rear junction box cover.
(2) Set multimeter select switch to ohms.
(3) Is continuity measured between rear
junction box assembly terminal wire
1435 and a known good ground?
(a) If there is no continuity, repair wire
1435 (see schematic, Fig FO-3)
or replace trailer main wire harness
and perform Step (4) below.
(b) If there is continuity, wire 1435
is OK.
(4) Install rear junction box cover.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |