 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2330-385-14
4-28. REAR MARKER LIGHTS/BRACKET REPLACEMENT (CONT).
(3)
Disconnect 1012-31 connector (6) from 489
connector (7) on left light.
(4)
Disconnect 1012-32 connector (6) from 489
connector (7) on center light.
(5)
Disconnect 1012-33 connector (6) from 489
connector (7) on right light.
(6)
Remove two locknuts (8), screws (9), wire
1435-34 (10), lens support (3) and gasket
(11) from light bracket (12). Discard
locknuts.
(7)
Remove two nuts (13) and lockwashers (14)
from bracket (12) and mounts (15). Discard
lockwashers.
(8)
Remove bracket (12) from mounts (15).
(9)
Remove two nuts (16), lockwashers (17)
and mounts (15) from frame (18). Discard
lockwashers.
b.
Installation.
NOTE
If only replacing lamp,
perform steps (9) and (10).
To properly secure bracket,
it may be necessary to
tighten upper and lower
nuts at the same time.
All three lights are installed
the same way.
Replace cable ties as
required.
(1)
Install two mounts (15) on frame (18) with
two lockwashers (17) and nuts (16).
(2)
Position bracket (12) on two mounts (15).
(3)
Install two lockwashers (14) and nuts (13)
on mounts (15).
4-346
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals