|
|
![]() TM 9-2330-385-14
NOTE
Allow cushion clamps to remain
on cable in Step (6).
(6)
Remove three locknuts (17), screws (18) and
two cushion clamps (19) on cable (20) from
winch bracket (21). Discard locknuts.
(7)
Remove winch (22) from winch bracket (21).
(8)
Pull cable (8) from hole in tire carrier (23).
(9)
Remove locking pin (24) and pin (25) from
pulley support tube bracket (26) and extend
pulley support tube (27) from pulley support
tube bracket until hole (28) in pulley
support tube is aligned.
(10)
Install pin (25) and locking pin (24) in
hole (28) of pulley support tube (27) and
pulley support bracket (26).
(11)
Remove locknut (29), screw (30), two
washers (31), pulley (32) and spacer (33)
from pulley support bracket (34). Discard
locknut.
(12)
Remove spacer (33) from pulley (32).
(13)
Remove locknut (35), screw (36), two
washers (37), spacer (38) and pulley support
bracket (34) from pulley support tube (27).
Discard locknut.
(14)
Remove locking pin (24), pin (25) and pull
pulley support tube (27) from pulley support
bracket (26).
4-537
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |