Installation. -725550984

TM 9-2330-385-14

5-13. REAR ELECTRICAL BOX REPAIR (CONT).

(b)

Remove wires (2) from resistor (3).

(c)

Remove nut (4) from resistor (3).

(d)

Remove resistor (3) and washer (5)

from hole (6) in cover (7).

(e)

Repeat Steps (a) through (d) for

remaining resistors (3).

(2)

Installation.

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors

and are harmful to skin and clothing. To avoid injury or death, keep away from open

fire and use in well-ventilated area. If adhesive, solvent, or sealing compound gets on

skin or clothing, wash immediately with soap and water.

NOTE

Replace cable ties as required.

(a)

Apply adhesive sealant around edge of resistor hole (6).

(b)

Apply sealing compound on threads of resistor (3).

(c)

Install resistor (3) and washer (5) on cover (7) with nut (4).

(d)

Slide two sections of heat shrink (1) over wires (2).

5-30