 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2330-385-14
5-17. AXLE NO. 2 ALIGNMENT (CONT).
NOTE
Distance A and B must be within
1/8 in. (3.2 mm) of each other.
(11)
Measure distance A and B.
NOTE
If distance A and B are within 1/8
in. (3.2 mm) of each other,
alignment is correct, go to
Step (18). If distance is not
within 1/8 in. perform Step (12).
(12)
Remove eight nuts (9), washers (10) and
screws (11) from spring seat cap (12) and
spring seat (13).
When aligning axle, do not
remove nuts in Step (13).
Failure to comply will result in
axle falling and possible injury or
death to personnel.
NOTE
Loosen nuts only enough to allow
axle to be moved.
(13)
Loosen eight nuts (14) on four U-bolts (15).
(14)
Adjust Axle No. 2 (5) by moving axle ends
forward or backwards until a 1/8 in.
(3.2 mm) tolerance is obtained.
(15)
Install eight screws (11), washers (10) and
nuts (9) to spring seat cap (12) and spring
seat (13). Tighten to 130 lb-ft (176 N.m).
(16)
Remove eight nuts (14) from four
U-bolts (15).
(17)
Install eight nuts (14) to four U-bolts (15).
Tighten to 220 lb-ft (298 N.m).
5-56
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals