 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2330-385-14
5-18. AXLE NO. 3 ALIGNMENT (CONT).
(8)
Remove eight nuts (8), washers (9) and
screws (10) on bracket (13).
When aligning axle, do not
remove nuts in Step (9). Failure
to comply will result in axle
falling and possible injury or
death to personnel.
NOTE
Loosen nuts only enough to allow
axle to be moved.
(9)
Loosen eight nuts (12) on four
U-bolts (13).
(10)
Adjust Axle No. 3 (5) by moving axle ends
forward or backwards until a 1/16 in.
(1.59 mm) tolerance is obtained.
(11)
Install eight screws (10), washers (9) and
nuts (8) on bracket (11). Tighten nut to 130
lb-ft (176 N.m).
(12)
Remove eight nuts (12) from four U-
bolts (13).
(13)
Install eight nuts (12) on four U-bolts (13).
Tighten nuts to 220 lb-ft (298 N.m).
5-60
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals