Cleaning/Inspection. -725551024

TM 9-2330-385-14

5-21. DRAWBAR REPAIR (CONT).

(12)

Remove two wiper seals (11) from drawbar

structure (1). Discard seals.

NOTE

Bushings have seams and are

removed by prying one edge of

seam inward.

(13)

Remove two bushings (12) from drawbar

structure (1). Discard bushings.

(14)

Remove two grease fittings (13) from

drawbar structure (1).

NOTE

Bushings have seams and are

removed by prying one edge of

seam, inward.

(15)

Remove four bushings (14) from drawbar

structure (1). Discard bushings.

Cleaning/Inspection.

(1)

Inspect tube shaft for warpage or damage

that would impair operation.

(2)

Inspect drawbar structure for warpage or

damage that would impair operation.

(3)

Remove adhesive sealant from end plate of

tube assembly.

Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face

shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and

clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when

using solvent; the flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees

C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may

result in injury or death to personnel.

If personnel become dizzy while using cleaning solvent, immediately get fresh air and

medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts

eyes, immediately flush eyes with water and get immediate medical attention.

Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only with

effective chip guarding and personal protective equipment (goggles/shield, gloves, etc).

(4)

Clean inside of drawbar structure with drycleaning solvent and dry with compressed air.

5-70